Life Cycle of a River

 

Life Cycle of a River

Definition of river In the high mountain, plateau or highland where rainfall, spring, glacier or melted waters from the glacier flow downwards due to gravitational force in a fixed course is called a River. The river flows in a course through plains and reaches at ocean or lake. The origin of the river is called the Source of river. The place where the river reaches the ocean or lake called the Mouth of the river. The extended area along the Mouth of the river is called the Estuary.

River course River is important in the life of the people. All ancient civilizations flourished beside the river. At that time river was the only medium through which people could move around.

Doab Land between two active rivers is known as doab.

Confluence: When two or more rivers meet together at a place is known as confluence.

Tributary A stream or river that flows into a main stream or a lake is called a Tributary. A tributary does not flow directly into a sea or ocean.

Distributary A stream that branches off and flows away from a main stream channel. They are common in the delta areas in the lower course of the river.

River valley A valley formed by flowing river is called by River valley.

River bed The river bottom through which river flows is called the River bed.

River basin The vast regions having branches of rivers through which water flows from its origin and fall into ocean and lake are called River basin.

On the basis of area, depth, slope, velocity from the source to the mouth of the river, the life cycle of a river has been divided into three stages (fig. 4.5). These are :

1. Youthful stage/upper course

2. Mature stage/middle course

3. Old stage/lower course

Life Cycle of a river

1. Youthful stage/upper course: Youthful stage/upper course is the primary stage of the river course. The upper course of the river is from the origin in the mountain up to reaching the plains. In the upper course or youthful stage the main work of the river is vertical erosion. In the upper course the river erodes the landforms and transports it.

2. Mature stage/middle course : When the river enters the plains it is called the  work starts. In Mature stage. In the mature stage the velocity of the river reduces and the deposition this stage lateral erosion is more than vertical erosion. In mature stage alluvium is deposited on the banks of the river which eventually forms the alluvial plains. Majority of lands in Bangladesh is alluvial plains.

3. Old stage/lower course : Lower course is the last stage of a river where it reaches the ocean. At this stage velocity of the river decreases. There is no vertical erosion and very less lateral erosion. River is very wide and shallow. Due to decrease of velocity of river flow, alluvium is deposited at the river mouth forming deltas.

Landforms from River Erosion

'V' shaped valley : In the upper course of the river due to high velocity large rocks are broken down and transported downwards. Mountains are formed with hard and soft rocks. In the river course soft rocks are eroded more and cutting downwards makes the channel shape like a 'V'. The sides of the mountains are less eroded as the lateral erosion at this stage is less (fig. 4.6). 

'V' Shaped Valley

Gorge and Canyon : A gorge is a narrow valley with steep rocky walls located between hills or mountains. Rivers carve through hard layers of rock, breaking down or eroding. Sediment from the worn away rock is then carried downstream. Over time, this erosion will form the steep walls of gorge (fig. 4.7). The Indus river gorge is 518 metres deep, one of the deepest in the world.

Gorge and Canyon

Canyon:

Canyon is a steep sided valley where depth is considerably greater than width. These features are the result of river erosion in the upper course of the river in dry region. In North America Grand Canyon is the largest in the world which 137-157 metres wide, approximately 2.4 kilometres deep and 482 kilometres long.

Waterfall

Waterfall : Waterfalls are found in the upper course of the river. They happen when there is a piece of hard rock overlaying a soft rock which the river cannot erode. So, water has to drop from a high place to a low place (fig. 4.8). Most waterfalls are small but the biggest waterfalls are hundreds of metres high. In North America Niagara falls in the Lawrence river has been formed this way.

Landforms from River Deposition

Alluvial cone and alluvial fan : An alluvial fan is a fan shaped or cone shaped deposit of gravel, sand and smaller materials.When water flows down a mountain, it picks up sand and other materials from the mountain. When the water reaches the base of the mountain and spreads out onto flat land, that material is deposited. As the materials builds up over time, an alluvial fan/and alluvial cone is created (fig. 4.9). In the foothills of Himalaya tributaries of Ganges forms these types of alluvial fans.

Alluvial Cone and Alluvial Fan

Piedmont alluvial plain : Mountainous river deposits sediments at the foothills of the mountains. These deposits gradually form extensive plains.These type of plains are known as piedmont alluvial plains (fig. 4.10).

Piedmont Alluvial plain
Adjacent areas of the rivers Tista, Karatoa and Atrai in Rangpur and Dinajpur regions of Bangladesh are known as the piedmont alluvial plains. These rivers originated in the Himalayas and brought sediments from the mountainous region and deposited in those region forming the piedmont alluvial plains.

Flood plain: A flood plain usually is a flat area with areas of higher elevation on both sides. Flood plains can be very small or very large. Small flood plains sometimes are part of a valley. Large flood plains can almost tae up entire country. Flood plains usually are very fertile agricultural areas (fig. 4.11).

Flood Plain

Floods carry sediment rich in nutrients. They spread that sediment to a wide area. Flood plains are flat and have relatively few rocks or other large obstacles that may prevent farming. Floods are usually seasonal and can be predicted months ahead of time.

Delta : Deltas form as rivers empty their water and sediment into another body of water, such as an ocean, lake, or another river. A river moves more slowly as it nears its mouth, or end. This causes sediment, solid material carried downstream by currents, to fall to the river bottom. The heavier, coarser material settles first. Smaller, finer sediment is carried farther downstream. The finest material is deposited beyond the river mouth. This material is called Alluvium or Silt. Silt is full of nutrients that help microbes and plants grow. As the silt builds up, new land is formed.

Formation of Delta of a River

Not all rivers form deltas. For a delta to form, the flow of a river must be slow and steady enough for silt to be deposited and build up. Because many river deltas have a triangular shape, the term delta comes from the upper-case Greek letter delta, which is shaped like a triangle (fig. 4.12).

Learn more about - 

👉👉 Internal and External Structure of the Earth

👉👉 External Structure of the Earth

1 تعليقات

  1. This article provided me with a wealth of information. The article is both educational and helpful. Thank you for providing this information. Keep up the good work. PP Butterfly Valve

    ردحذف
أحدث أقدم